Pride VOGUE, Руководство пользователя

Страница: 26 / 44

26 www.pridemobility.com Vogue
Controller Position
You can move the controller in toward or out away from the
armrest, or change the position of the controller for either left-
hand or right-hand use.
MANDATORY! Prevent controller harness
damage! Avoid routing the controller harness
on the outside of the armrest pad. Route the
harness under the armrest or toward the
inside of the armrest pad. Use correct tie-
down points for the controller harness to
prevent the harness from getting caught in
the drive tyres, pinched in the seat frame, or
damaged when passing through doorways.
NOTE: Your controller will be attached either by a mounting
block or a figure 8 assembly. Be sure to follow the correct set of
instructions below when changing the position of your controller.
To change the controller position in a mounting block:
1. Turn off the power to the controller.
2. Unplug the controller connector from the front of the
power base. See figure 6.
3. Remove any wire ties securing the controller cable to the armrest.
4. Loosen the mounting screws in the controller mounting
block. See figure 18.
5. Move the controller mounting block and controller to the
other armrest and tighten the mounting screws.
6. Use wire ties to secure the controller cable and the manual
recline lever cable to the armrests.
7. Route the controller cable to the front of the power base
and reconnect the controller. See figure 20.
To change the controller position in a figure 8 assembly:
1. Turn off the power to the controller.
2. Unplug the controller connector from the front of the
power base. See figure 6.
3. Remove any wire ties securing the controller cable to the
armrest.
4. Loosen the setscrews on the figure 8 clamp assembly
located on the armrest. See figure 19.
5. Slide the controller out of the loosened clamp assembly.
6. Loosen the setscrews on the clamp assembly on the other
armrest.
7. Remove the manual recline lever assembly and insert it
into the clamp assembly on the opposite armrest. See
figure 10.
8. Tighten the setscrews to secure the manual recline lever
assembly in the figure 8 clamp.
9. Insert the controller into the remaining open clamp assembly.
10. Tighten the setscrews to secure the controller in the figure
8 clamp.
11. Use wire ties to secure the controller cable and the manual
recline lever cable to the armrests.
12. Route the controller cable to the front of the power base
and reconnect the controller. See figure 20.
I V . C O M F O R T A D J U S T M E N T S
Figure 19. Controller Position (Figure 8
Assembly)
Figure 18. Controller Position (Standard
Mounting Block Shown)
Figure 20. Cable Routing
MOUNTING BLOCK
MOUNTING SCREWS
SETSCREWS
FIGURE 8 CLAMP
ASSEMBLY
SETSCREWS