Pride Sundancer, Руководство пользователя

Страница: 24 / 30

24 Sundancer
Figure 13. Unplug the Rear Light Harness Figure 14. Unplug the Front-to-Rear Connector
No tools are required to disassemble or assemble your Sundancer. Always disassemble or assemble your Sundancer
on a level, dry surface with sufficient room for you to work and move around your Scooter. Keep in mind that the
disassembled sections of your Scooter take up more floor space than the assembled Scooter.
V I I I . D I S A S S E M B L Y A N D A S S E M B L Y
DISASSEMBLY
You can disassemble your Sundancer into seven or eight pieces: the seat, the front frame, the front basket, the rear
frame, the rear shroud, and the two batteries; you can also remove the utility tray from the rear frame, if necessary.
Place your Scooter in an area where you have sufficient clearance to move the parts around. You need approximately
1.5 meters in all directions. You may need assistance to lift some of the Scooter components. See III. “Specifications”
for individual component weights.
1. Place the freewheel lever in the drive (down) position.
2. Ensure the seat is locked into position, then lift the seat up and off of your Scooter.
3. Gently lift the rear shroud off of your Sundancer. If your Scooter is equipped with rear lights, you will not be
able to fully remove the rear shroud until you perform step 4.
4. Unplug the rear light harness, if so equipped. See figure 13.
5. Unplug the large, white front-to-rear connector that attaches the front control console harness to the utility tray.
See figure 14.
6. Disconnect the battery tie-down straps, unplug both battery harnesses, and lift both batteries off of the Sundancer.
See figures 15 and 16.
CAUTION! Failure to unplug both battery harnesses and the control console harness prior to
disassembly could result in permanent damage to your Sundancer.
7. If you plan to remove the utility tray, disconnect the 6-pin motor harness plug. See figure 17. If you do not plan
to remove the utility tray, go to step 10.
NOTE: You can decrease the weight of the rear component by removing the utility tray.
8. Lift up and remove the utility tray (optional) if you want to decrease the weight of the rear component.
9. Pull up on and remove the front basket.