Pride Rally shopper, Руководство пользователя

Страница: 33 / 39

33
Rally Shopper
Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that
may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because
the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.
If you experience any problems with your scooter that you are unable to handle, immediately contact your autho-
rized Pride provider for information, maintenance, and service.
X . T R O U B L E S H O O T I N G
PROBLEM
POSSIBLE SOLUTIONS
All of my scooter systems appear to be “dead.”
One of the following actions may eliminate the problem.
n Remove and reinsert the key in the key switch.
n Ensure the batteries are fully charged.
n Push in the main circuit breaker reset button.
n Ensure both battery harnesses are firmly connected to the
electronic controller assembly and to the battery terminals.
n Ensure the front-to-rear harness connector is firmly connected.
n Ensure the seat safety pressure switch harness beneath the
seat is connected.
My scooter’s battery condition meter shows a full charge,
but my scooter does not move when I push the throttle
control lever.
n Ensure your scooter was not left in freewheel mode.
(Push down on the manual freewheel lever to restore nor-
mal operation.)
NOTE: When the manual freewheel lever is pulled up, your
scooter’s brakes are disengaged and all power to the motor/
transaxle assembly is cut.
n Ensure the seat safety pressure switch harness beneath the
seat is connected.
My scooter’s main circuit breaker repeatedly trips. One of the following actions may eliminate the problem.
n Charge your scooter’s batteries more frequently.
n Have both of your scooter’s batteries load tested by your
authorized Pride provider.
n Obtain a battery load tester at most any automotive parts
store; follow the directions supplied with the load tester.
My scooter’s battery condition meter dips way down and
the motor surges or hesitates when I press the throttle
control lever.
One of the following actions may eliminate the problem.
n Fully charge your scooter’s batteries.
n Have your authorized Pride provider load test each battery.
n Obtain a battery load tester at most any automotive parts
store; follow the directions supplied with the load tester.