Pride Rally shopper, Руководство пользователя

Страница: 24 / 39

24 Rally Shopper
V I . B AT T E R I E S A N D C H A R G I N G
Your scooter requires two long-lasting, 12-volt, deep-cycle batteries that are sealed and maintenance free. They
are recharged by an onboard 3-amp charging system designed for ease of use and convenience.
n Charge your scooter’s batteries prior to using it for the first time.
n Keep your batteries fully charged to keep your scooter running trouble free.
READING YOUR BATTERY VOLTAGE
The battery condition meter on the control console assembly indicates the approximate strength of your batteries
using a color code. Green indicates fully charged batteries, yellow a draining charge, and red indicates that an
immediate recharge is necessary. See figure 8. To ensure the highest accuracy, the battery condition meter should
be checked while operating your scooter at full speed on a dry, level surface.
CHARGING YOUR BATTERIES
Follow these easy steps to charge your batteries safely:
WARNING! Never use an extension cord to plug in your battery charger. Plug the charger
directly into a properly wired standard wall outlet.
The onboard battery charger is equipped with two Light Emit-
ting Diodes (LEDs). You can check the charge status of the
batteries during charging by looking at the LEDs. See figure 9.
n A lit Red LED indicates the batteries are charging.
n A lit Green LED indicates the batteries are fully charged.
NOTE: It is not necessary to remove the rear shroud while
charging the batteries. The charger LEDs can be viewed
through the cutout in the right side of the rear shroud.
CHARGER LEDS
Figure 8. Battery Condition Meter
1. Position your scooter close to a standard wall outlet.
2. Remove the key from the key switch.
3. Make certain that the manual freewheel lever is in the
drive (down) position.
4. Plug the charger power cord into the charger power cord
receptacle.
5. Plug the charger power cord into a standard wall outlet.
When the batteries are fully charged, unplug the charger power cord from the wall outlet and then from the charger
power cord receptacle.
NOTE: There is a charger inhibit function on your scooter. The scooter will not run and the battery
condition meter will not operate while the batteries are charging.
Figure 9. Charger LEDs
(Rear Shroud Removed For Clarity)
BATTERY CHARGER FUSE