Pride PATHRIDER ES10, Руководство пользователя

Страница: 35 / 44

35 www.pridemobility.com Pathrider ES10
FRAME
LOCK-UP
PIN
SAFETY
LATCH
V I I . D I S A S S E M B L Y A N D A S S E M B L Y
FRAME SEPARATION
1. Lower the tiller and tighten the tiller adjust-
ment knob.
2. Remove the frame lock-up pin. See figure
26.
3. Lift up on the seat post and pivot the rear
section rearwards until the frame hooks are
no longer resting on the lower frame tube.
See figure 27.
4. Slowly separate the two sections of the
scooter. See figure 27.
NOTE: The pivoting tiller is equipped with a
mechanism that will lock the front wheels in
place when the tiller is completely lowered and
secured.
ASSEMBLY
1. Position the front and rear sections of your
scooter as shown in figure 27 .
2. Lift the front section as you align the frame
hooks of the front section with the lower
frame tube of the rear section. See figure 27.
3. Once the frame hooks are over the lower
frame tube, lower the front section com-
pletely. This will engage the frame lock-up.
4. Reinstall the frame lock-up pin.
WARNING! Ensure that the frame
lock-up pin is properly installed
and that the pin safety latch is
secured before driving the
scooter.
5. Raise the tiller and fully tighten the tiller
adjustment knob.
6. Reinstall the batteries to the battery wells.
7. Connect both battery harnesses. See figure 25.
8. Secure the battery tie-down strap.
9. Reconnect the front-to-rear harnesses.
10. Reinstall the battery shroud.
11. Reinstall the seat and rotate it into place.
WARNING! After assembly, make
absolutely certain the tiller lock
knob is in the unlocked position
before driving the scooter.
Figure 26. Frame Lock-up Pin
Figure 27. Frame Separation
FRAME HOOKS
LOWER FRAME TUBE