Pride CELEBRITY XL DELUXE, Руководство пользователя

Страница: 40 / 48

40
www.pridemobility.com Celebrity XL Deluxe
I X . C A R E A N D M A I N T E N A N C E
Your scooter requires a minimal amount of care and maintenance. If you do not feel confident in your ability to
perform the maintenance listed below, you may schedule inspection and maintenance at your authorised Pride
Provider. The following areas require periodic inspection and/or care and maintenance.
TYRE PRESSURE
!
If equipped with pneumatic tyres, always maintain the psi/bar/kPa air pressure indicated on each tyre.
WARNING! It is important that the psi/bar/kPa air pressure indicated on each tyre be maintained
in pneumatic tyres at all times. Do not underinflate or overinflate your tyres. Low pressure may
result in loss of control, and overinflated tyres may burst. Failure to maintain the psi/bar/kPa air
pressure indicated on pneumatic tyres at all times may result in tyre and/or wheel failure.
!
Regularly inspect your scooter’s tyres for signs of wear.
WHEEL REPLACEMENT
If your scooter is equipped with pneumatic tyres and you have a flat tyre, you can have the tube replaced. If your
scooter is equipped with a solid tyre insert, either the solid insert or the entire wheel must be replaced depending on
model. Contact your authorised Pride Provider for information regarding replacement wheels for your scooter.
WARNING! Wheels on your scooter should only be serviced/replaced by an authorized
Pride Provider or qualified technician.
WARNING! Completely deflate pneumatic tyres before dismantling the rim or attempting
repair.
WARNING! When changing a tyre, remove only the center lug nut, then remove the wheel.
If any further disassembly is required, deflate the tyre completely or it may explode.
EXTERIOR SURFACES
Bumpers, tyres, and trim can benefit from an occasional application of rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the scooter’s vinyl seat or tyre tread,
as this may cause them to become dangerously slippery.
CLEANING AND DISINFECTION
!
Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your scooter. Avoid
using products that may scratch the surface of your scooter.
!
If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for use on
your product before application.
WARNING! Follow all safety instructions for the proper use of the disinfectant before
applying it to your product.
ABS PLASTIC SHROUDS
!
The shrouds of the scooter are formed from durable ABS plastic and are coated with an advanced formula
urethane paint.
!
A light application of car wax will help the shrouds retain their high gloss.