Pride ATHENA, Руководство пользователя

Страница: 22 / 40

22 www.pridemobility.com Athena
V . C O M F O R T A D J U S T M E N T S
COMFORT ADJUSTMENTS
After becoming familiar with your power chair’s operation, you may find the need to make some adjustments to
increase your comfort such as controller position and anti-tip wheel height.
NOTE: If your power chair is equipped with a Synergy Seat or TRU-Balance Power Positioning System, refer
to the information provided in separate manuals.
WARNING! The centre of gravity of your power chair was factory set to a position that meets the
needs of the demographic majority of users. Your Quantum Rehab Dealer has evaluated your
power chair and made any necessary adjustments to suit your specific requirements. Do not
change your seating configuration without first contacting Pride Mobility Products Ltd. or your
Quantum Rehab Dealer.
WARNING! Your seat should only be installed or adjusted by a Quantum Rehab Dealer.
WARNING! Some power chair components are heavy. You may need assistance to lift or carry
them. Please refer to “Appendix I - Specifications” for specific component weights before you
disassemble the power chair.
WARNING! Remove the occupant from the power chair before making any adjustments.
NOTE: Any nylon insert lock nut removed during the disassembly or adjustment of the power chair must be
replaced with a new nut. Nylon insert lock nuts should not be reused as it may cause damage to the nylon insert,
resulting in a less secure fit. Replacement nylon insert lock nuts are available at local hardware stores or
through your Quantum Rehab Dealer.
You may need the following to make comfort adjustment s:
metric/standard hex key set
metric/standard socket set and ratchet
adjustable wrench
Controller Position
You can position the controller for either left-hand or right-hand use. You can also adjust the extension of the
controller from the armrest.
WARNING! Do not place the controller harness so that it can be pinched in the seat frame or the
power base frame.
Figure 12. Adjusting Controller Position
SETSCREWS
MOUNTING SCREWS
MOUNTING BLOCK
To change the controller position:
1. Turn off the power to the controller.
2. Unplug the controller connector from the power base.
3. Remove any wire ties securing the controller harness to
the armrest.
4. Loosen the mounting screws in the controller mounting
block. See figure 12.
5. Move the controller mounting block and controller to
the other armrest and tighten the mounting screws.
6. Route the controller harness to the front of the power
base and reconnect the controller. See figure 10.
7. Secure the controller harness to the armrest receiver
with wire ties if desired.