Pride Air, Руководство пользователя

Страница: 19 / 32

Jazzy Air www.pridemobility.com 19
V. B AT T E R I E S A N D C H A R G I N G
To charge the batteries using the off-board
charger:
1. Position the front of your power chair next to a
standard electrical outlet.
2. Be certain the controller power is turned off and
the freewheel levers are in the engaged position.
See III. “Your Power Chair.”
3. Plug the off-board charger into the off-board
charger/programming socket on the controller.
See fi gure 13.
4. Plug the off-board charger into the electrical outlet.
WARNING! The LED lights on the
charger indicate different charger
conditions at various times: charger
power on, charging in progress, and
charging complete. If the LED does
not indicate that charging is complete
within 24 hours, unplug the charger
and contact your authorized Pride
Provider. Refer to the manual supplied
with the charger for a complete
explanation of these indicators.
Figure 13. Battery Charging
5. When the batteries are fully charged, unplug the off-board charger from the electrical outlet and then from the
controller.
Battery Break-in
To break in new batteries for maximum effi ciency:
1. Fully recharge any new battery prior to its initial use. This brings the battery up to about 90% of its peak
performance level.
2. Operate your power chair throughout the house and yard. Move slowly at fi rst, and do not travel too far until
you become accustomed to the controls and break in the batteries.
3. Give the batteries another full charge of at least 8 to 14 hours and operate your power chair again. The batteries
will now perform at over 90% of their potential.
4. After four or fi ve charging cycles, the batteries will top off at 100% charge and last for an extended period.
Frequently Asked Questions (FAQs)
How does the charger work?
The battery charger takes the standard electrical outlet voltage (alternating current) and converts it to 24 VDC (di-
rect current). The power chair batteries use direct current to run your power chair. When the battery voltage is low,
the charger works harder to charge the battery. As the battery voltage approaches full charge, the charger doesn’t
work as hard to complete the charging cycle. When the battery is fully charged, the amperage from the charger is
nearly at zero. This is how the charger maintains a charge but does not overcharge the battery.
Can I use a different battery charger?
You should use the charger supplied with the power chair. It is the safest, most effi cient tool to charge the batteries.
We do not recommend using other types of chargers (e.g., an automotive battery charger).
XLR