Pride Mobility QUANTUM 1402, Руководство пользователя

Страница: 18 / 47

18 www.quantumrehab.com Quantum 1402
Electronics Tray
The electronics tray is located on the rear of your power chair. The electronics tray is located underneath the rear
sliding door and consists of the ammeter, the charger power cord receptacle, the main circuit breaker, accessory
connector (optional equipment), and the controller connectors(s). See figure 6.
Ammeter: The ammeter displays the charger’s current output in amps. For more information, see VII. “Batteries
and Charging” in this manual.
Charger Power Cord Receptacle: This receptacle is used whenever the batteries need recharging.
Main Circuit Breaker: The main circuit breaker is a safety feature built into your power chair. When the batteries
and the motors are heavily strained (e.g., from excessive loads), the main circuit breaker trips to prevent damage to
the motors and the electronics. If the circuit trips, allow your power chair to “rest” for approximately one minute.
Next, push in the circuit breaker button, turn on the controller, and continue normal operation. If the main circuit
breaker continues to trip repeatedly, contact your authorized Quantum Rehab Specialist.
Accessory Connector (Optional): This is where the optional power harness connects to the controller.
Controller Connector(s): This is where the controller connects to the power base. Each controller uses a different
type of cable. Regardless of which type of controller is used, the cable must be secured to the seat assembly and not
allowed to drag on the floor.
Power Seat Connector (Optional): This is for the optional power seat switch.
I I I . Y O U R P O W E R C H A I R
Figure 6. Electronics Tray
AMMETER
CONTROLLER CONNECTOR
CHARGER POWER LEAD RECEPTACLE
(SHOWN COVERED)
MAIN CIRCUIT BREAKER