Pride Mobility LiNX Controller, Основные инструкции по эксплуатации

Страница: 11 / 16

11
Care and Maintenance
Refer to your power chair owner’s manual for proper cleaning and disposal instructions.
Warranty
Refer to your power chair owner’s manual for specific information on the controller warranty.
Error Codes
The on/off key will flash red to indicate error codes when the LiNX controller detects an abnormal
condition in the electrical system. The on/off key will flash a number of times quickly, then pause, then
flash again. The on/off key will continue to flash the error codes until the problem is fixed. The following
table identifies the individual error codes. If any of these error codes persist or if you experience any
other problem with your power chair, contact your authorized Pride Provider.
NOTE: When the on/off key flashes an error, the battery condition meter LEDs will also flash an
inhibit. See “Battery Condition Meter.”
Error Code Probable Cause Possible Solution
1 Remote/joystick error Check cables and connectors. Replace
remote.
2 Network or configuration error Check cables and connectors. Check
Bluetooth pairing. Reconfigure the system.
Recharge the battery. Check charger.
Replace modules. Contact supplier.
3 Left motor fault Check the left motor, connections, and
cables.
4 Right motor fault Check the right motor, connections, and
cables.
5 Left park brake fault Check the left park brake, connections, and
cables.
6 Right park brake fault Check the right park brake, connections,
and cables.
7 Module error (other than Remote) Check cables and connectors. Check
modules. Replace LiNX Access Key.
Replace Power Module. Recharge battery.
If the chair stalled, reverse away or remove
obstacles, or if the chair was moved while
turned off, cycle the power.