30
www.pridemobility.com
Quantum Jazzy 1650 Series
V I . B A T T E R I E S A N D C H A R G I N G
Battery Break-in
To break in new batteries for maximum efficiency:
1. Fully recharge any new battery prior to its initial use. This brings the battery up to about 90% of its peak
performance level.
2. Operate your power chair throughout the house and yard. Move slowly at first, and do not stray too far until
you become accustomed to the controls and break in the batteries.
3. Give the batteries another full charge of 8 to 14 hours and operate your power chair again. The batteries will
now perform at over 90% of their potential.
4. After four or five charging cycles, the batteries will top off at 100% charge and last for an extended period.
Frequently Asked Questions (FAQs)
How does the charger work?
The battery charger takes the standard electrical outlet voltage of 120 VAC (alternating current) and converts it
to 24 VDC (direct current). The power chair batteries use direct current to run your power chair. When the battery
voltage is low, the charger works harder to charge the battery. As the battery voltage approaches full charge, the
charger doesn’t work as hard to complete the charging cycle. When the battery is fully charged, the amperage from
the charger is nearly at zero. This is how the charger maintains a charge but does not overcharge the battery.
Can I use a different battery charger?
You should use the charger supplied with the power chair. It is the safest, most efficient tool to charge the batteries.
We do not recommend using other types of chargers (e.g., an automotive battery charger).
NOTE: Your power chair’s charger will not operate after the batteries have been discharged to nearly zero
voltage. If this happens, call your Quantum Rehab Provider for assistance.
How often must I charge the batteries?
Many factors come into play when deciding how often to charge the batteries. You may use your power chair all
day on a daily basis or you may not use it for weeks at a time.
To charge the batteries using the off-board
charger:
1. Position the front of your power chair next to a
standard electrical outlet.
2. Be certain the controller power is turned off and the
freewheel levers are in the engaged position. See
III. “Your Power Chair.”
3. Plug the off-board charger into the off-board
charger/programming socket on the controller.
See
figure 19.
4. Plug the off-board charger into the electrical outlet.
NOTE: The LED lights on the charger indicate
different charger conditions at various times:
charger power on, charging in progress, and
charging complete. Refer to the manual supplied with
the charger for a complete explanation of these
indicators.
5. When the batteries are fully charged, unplug the
off-board charger from the electrical outlet and
then from the controller.
Figure 19. Battery Charging
