PRG VARI LITE VL5, Руководство по обслуживанию

Страница: 51 / 142

VL5 ™ WASH LUMINAIRE SERVICE MANUAL 41
Step 7. Remove linear actuator motor assemblies.
a. At linear actuator motor assemblies, using #2 slotted screwdriver, disconnect actuator/drive ring links
from swivel links on drive rings.
b. At each linear actuator motor assembly heatshield, using #1 Phillips screwdriver, remove four 4-40 X 1/
4" PPZ screws and four #4 lock washers securing heatshield to luminaire head.
Step 8. At linear actuator motor, using #1 Phillips screwdriver, remove two 4-40 X 1/4" PPZ screws and two #4 lock
washers securing linear actuator motor and heatsink to actuator mount, and remove motor and heatsink.
Step 9. Separate heatsink from linear actuator motor.
Step 10. Discard linear actuator motor.
Step 11. Place heatsink on new linear actuator motor.
Step 12. Place linear actuator motor and heatsink in place on actuator mount.
Step 13. Re-install two 4-40 X 1/4" PPZ screws and two #4 lock washers and, using #1 Phillips screwdriver, tighten
to secure linear actuator motor and heatsink to actuator mount.
Step 14. Secure actuator/drive ring link to drive ring swivel link.
Step 15. Feed linear actuator motor assembly wires into motor wire spring and push wires through spring until
exposed at other end.
Step 16. If linear actuator motor assembly wires have colored heatshrink markers to denote filter color (diffuser is
white, bellows has none), replace heatshrink or use colored tape.
Step 17. Using MTA crimp gun, crimp wires with a 4-pin MTA connector using the following pinouts:
Step 18. Install strain relief cover on MTA connector.
Step 19. Connect MTA connector to LCB header.
Step 20. Re-install board-side yoke leg cover.
Step 21. Re-install top and bottom head covers.
Step 22. Close and latch heatsink assembly and front lens ring.
Pin Wire
4 Green
3 Blue
2 Black
1 Red