IS-18904
Page 3 / 5
Writer:
<QF7720959 rev 5>
ml
4. Remove the protective paper on both sticky
back gaskets #380143.
5. Install both gaskets on the back face of the
camera (Figure 4).
FIGURE 4
6. Run the camera wiring thru the center hole on
the vehicle rear cap (Figure 5).
FIGURE 5
7. Install the rubber seal supplied with the camera
into the center hole as shown in Figure 6.
8. Make sure the split on the rubber seal is facing
down before fixing the camera (Figure 6).
FIGURE 6
