PRETUL PIPI-26, Руководство пользователя

Страница: 7 / 20

7
Start Up
ENGLISH
• Turn the adjusting screw ( A ) in a counterclockwise
direction to increase the volume of the material to be
sprayed.
• Turn the adjusting screw in a clockwise direction to
diminish the volume of the material to be sprayed.
Volume Selector
• Start the compressor.
• Press the trigger (
B
) to open the air flow and start
suctioning the product from the jar. Point the paint gun
towards a piece of cardboard until the spray flows.
• Release the trigger to stop the spray flow.
• To get the best result keep the gun always level and
parallel to the surface ( C ). Keep the nozzle 10” – 14” away
from the surface and spray evenly from side to side and up
and down. Do not spray in an angle otherwise the paint
may run through the surface. Do soft and uniform passes.
When spraying large surfaces use a crossed pattern ( D ).
• Move the gun with a steady and uniform speed. Fast
movements produce thinner layers. Slow movements
produce thicker layers.
• Apply one layer at a time. In the event of needing a
second layer read the drying recommendations from the
product manufacturer before applying an extra layer. Remember that to get a better finish applying two thin layers is better
than only one thick layer.
• When spraying small areas turn the adjusting screw to lessen the volume of the material. This prevents using too much
paint and over-spraying
• To assure a uniform application, do not pause while spraying an object when possible.
• Do not tilt the paint gun in an angle higher than 45°.
Start up
Spraying Techniques
B
C
D
A