PRETUL EBA-5P, Руководство пользователя

Страница: 15 / 24

3
EBA-5P
29994
5”
Class I
60 Hz
Bench Grinder
18 AWG X 3 C with insulating temperature of 221 °F
0,9 A
1/6 Hp
30 minutes work per 15 minutes idle. Maximum 6 hours per day
Code
Description
Grinding Wheels
Voltage
Frequency
Current
Power
3 450 RPM
Speed
Duty cycle
Conductors
Insulating
127 V
Technical Data
Power Cord Grips used in this product: Type “Y”
Tool Build Quality: Basic Insulation
Thermal insulation on motor winding: Class B
ENGLISH
Power Requirements
From 0 and up to 10 A
From 10 and up to 13 A
From 13 and up to 15 A
From 15 and up to 20 A
18 AWG
16 AWG
14 AWG
8 AWG
16 AWG
14 AWG
12 AWG
6 AWG
3 (one grounded)
From 6 ft to 49 ft | Higher than 49 ft
Ampere
Capacity
Number of
Conductors
Extension Gauge
WARNING
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a Authorized Service Center.
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
Before gaining access to the terminals all power sources should be disconnected.
CAUTION
WARNING When operating power tools outdoors, use a grounded
extension cable labeled “For Outdoors Use”. These extensions are specially designed for
operating outdoors and reduce the risk of electric shock.
If faults or breakdowns happen. Ground connection offers a
trajectory with minimum resistance for electric power. It reduces the risk of electric
shock. This tool is built with a power cable with an earth conductor and ground
connection. The plug shall be connected into a power outlet installed and grounded
according to all local codes.
When using an extension cord, verify the gauge is enough for the
power that your product needs. A lower gauge cable will cause voltage drop in the
line, resulting in power loss and overheating. The following table shows the right size to use depending on cord´s length and the
ampere capability shown in the tool’s nameplate. When in doubt use the next higher gauge.
WARNING