Pairing with Wireless Switches
Place
SWITCH 125
or
SWITCH 75
close to
ENERGISE
and briefly press Pair 1 button [5] on
ENERGISE
. Pair LED 1 [7] will flash slowly. Immediately press the Pair button on the wireless
switch. Pair 1 LED will continue to flash slowly until pairing is complete when the LED will light
steadily for 5 seconds.
You can pair up to three wireless switches with each channel of
ENERGISE
, allowing collaboration
between several users. If you attempt to pair a fourth switch, the switch that was used least
recently will be replaced with the new one. The other two switches are unaffected.
Repeat the procedure to pair further wireless switches with pair 2 button [6] on
ENERGISE
. Pair
LED 2 [8] will flash during the process.
The procedure to pair
SEND
with
ENERGISE
is exactly as for
SWITCH 125/SWITCH 75
; or any
combination of these.
Whenever
ENERGISE
receives a wireless transmission, the Pair LED [7]/[8] blinks as an
acknowledgement. This is useful when finding which switch is paired with a particular channel.
If at any stage you would like to clear the pairing on either channel, press and hold its respective
pairing button [5/6] until the pairing LED [7/8] flashes rapidly. The pairing information for all
three switches will be erased, allowing you to start over.
Output Status
The Pair LEDs also indicate the status of the output channels [1]/[2]. If channel 1 is activated,
Pair LED 1 [7] lights and if channel 2 is activated, Pair LED 2 [8] lights. The LEDs still blink briefly
if a wireless transmission is received.
Control Modes
ENERGISE
has six modes of control, four
of which can be used with either one or two
switches, and two modes which require two
switch operation.
One or two switch modes:
•
DIRECT
: the appliance activates while any
switch is held down and stops when all
switches are released.
•
LATCH
: one press activates the appliance
the next press stops the appliance.
•
TIMED SECONDS
: one press turns the
appliance on for the number of seconds
selected.
•
TIMED MINUTES
: one press turns the
appliance on for the number of minutes
selected.
NOTE
: In the above modes, when using two
switches and two appliances, the operating
modes may be different for each of the two
channels e.g. one appliance operating in
DIRECT mode and one appliance operating in
TIMED SECONDS.
Two switch modes:
•
CO-OPERATIVE: At least one switch on
each channel must be held down for both
appliances to operate.
•
ON/OFF: Pressing any switch on channel
1 turns both appliances on; pressing
any switch on channel 2 turns both
appliances off.
Содержание Simplyworks ENERGISE
Страница 4: ...1 2 3 4 5 6 7 8 9 10 ...
