Nn
1 knob is turned
Jf
mbet, after the contro
ed to any ON
atinually turn itself ON and OFF to contr.
Position below HI, the heater
ol the heat output. Thi
ious;
i
.
This
m
always be obvious; due to residual heat in the heating element, it will con
not
Jow at most settings. You may also hear aslig
inue to
ht clicking or hummin
i
g
sound
as
the
ostat cycles the heating elements ON and OFF o
rent whe in a darkened room.
F see a small spark or flash of
If additional heat is desired, turn the control knob to a higher setting. This will
jengthen the ON cycle and the heater will produce more heat. If less heat is desired
tum the knob to a lower setting. The ON cycle will then be shortened, producing less
heat.
After use, turn the control knob to the OFF position and disconnect the plug from
the wall outlet. Always disconnect by grasping the plug, not the cord. Pulling on
or yanking the
cord can damage the
cord’s
insulation and wires, making the heater
unsafe to use. WARNING! Never use a heater with a damaged cord.
will
co
Care, Cleaning, and Storage
Allow heater to cool completely before cleaning, caring for, or storing it. Also be sure
heater is turned off and unplugged.
1.
we
ol
Do not pour or spray any water. <!eaners, or any liquid on or into any portion of the
heater. Do not submerge heat":
=
=»
.
Use
a
soft,
lint-free,
damp
c!:
-nild
detergent
to
clean
the
exterior
surfaces.
Harsh or abrasive cleaners
‘
the finish.
.
Occasionally,
the
ssside
the
grille
will
need
to
be
cleaned
to
-
remove
dust
accumulation.
T»
rerove
dust
from
the
parabolic
reflector,
you
may
-
Grasp
the
handle
and
tilt
the
heater
down
to
the
storage
po
purchase d specially designed cleaning device such as the one offered on the
Important Instructions sheet enclosed. You may also dust the reflector by following
these simple steps: 1) Unplug the heater and allow to cool; 2) support the heater on
its back; 3) slip a soft, lint-free cloth through the grille; 4) move the cloth over the
surface of the parabolic reflector by inserting a long thin handle (such as a dowel or
the handle portion of a wooden spoon) through the grille, using it to slide the cloth
from spot to spot over the surface of the reflector; 5) remove the handle and the cloth
when the surface is dust free.
NOTICE: If you allow dust to build up on the parabolic reflector, the dust accumula-
tion may cause the heater to overheat and the warning buzzer to sound. If this should
occur, follow the POWER RESET INSTRUCTIONS on the back of the unit. Then
clean the parabolic reflector as previously instructed.
.
Ifthe
heater
does
not
work
properly
after
cleaning
and
following
the
reset
instructions, contact the Consumer Service Department at 1-800-877-0441 or at
Www.GoPresto.com/contact.
.
Wind
the
cord
around
the
built-in
cord
wrap
(Fig.
A,
page
3)
for
convenient
storage.
Keep heater in a dry location.
sition. You will feel and
hear it lock inplace.