she heater js controlled by a thermostat that shuts the
ier off ifit overheats,
It 1s placed too close to
hea
oF t0 8 wall or if too much dust or dirthas
cumulated on the parabolic reflector. To ensure that
ace are aware that an overheat situation has occurred
he heater will turn off and buzz until youmanually
reset it. TO reset, press the red recessed POWER RESET
putton located on the top of the heater between the dish
‘and the control knob (Fig. C).
Fig. C
Red power
Teset button
if
you hear continuous buzzing, confirm that the heater
is on a
level surface and not in the storage position. If
it continues, the heater has overheated due to incorrect
positioning or dirt or dust accumulation on the reflector.
Tilt
adjustment
screw
1. Turn the thermostatic control knob dial to OFF.
4. Wait 5 minutes to allow heater to cool.
Cord wrap
3. Press the red recessed POWER RESET button
with a Phillips screwdriver or similar tool (Fig. C).
Holding the screwdriver at about a 45° angle, press until you hear a click. If you
do not hear the click, continue to press it in. The click is an audible signal that the
button has been reset.
4. Verify heater is correctly posi’
(see positioning instructions below) and clean the
reflector if it is dirty or
ated on page 7.
5. Plug the heater back in ar.
Positioning the Heater
When positioned correctly, the parabolic heater will keep you toasty warm. Follow these
suggestions for maximum warmth:
1. Point the front grille towards the area in which heat is desired and use the tilt feature
to aim the heat right where you want it.
2. Check to make sure there are no objects between you and the heater. Such objects
will absorb the heat and prevent it from reaching you.
3. Place the heater at least 3 feet but no more than 10 feet away. The parabolic design
of the reflector focuses heat at persons 3 to 10 feet away. Thus, for your entire body
to enjoy the heat produced by the heater, it must be placed at least 3 feet from you.
Placing it closer will turn the heater into a foot warmer, rather than a body warmer.
Experiment with various positions until you find the one that is right for you.
4. Remember, this unit is primarily a people heater rather than a room heater and using
it to heat a large room or open area is not recommended. The infrared heat produced
by this heater will travel through glass, just like the sun’s rays. If the heater 1s aimed
at a window, objects outside will be heated.