3
6. Attach the cord to the unit by aligning the magnetic plug end of the cord assembly
with the two electrical pins located in the recessed area of the fryer base (Fig. B).
When properly aligned, the plug will magnetically attach itself to the appliance.
For proper connection, the magnetic plug end must be parallel with the
countertop
(Fig. C)
.
Important: The magnetic cord was designed to detach easily from the fryer. As a
result, if it is bumped or touched during use, it could possibly detach causing the
unit to stop heating. Avoid contact with cord during operation. If contact occurs,
verify that the cord is still properly connected.
7. Plug cord into a 120 volt wall outlet. The unit is now “oN” and will remain on
until it is unplugged.
8. Preheat 8 cups of oil for 20 minutes. Preheat 6 cups of oil for 15 minutes. Note:
occasionally you may hear a pop or clicking sound while the fryer
is preheating. This is normal and a sign of fast heatup. you may
also notice this sound as the unit cools down.
9. Gently place 1 to 8 cups of food into unit if using 8 cups of oil. If
using 6 cups of oil, place 1 to 6 cups of food into unit. Use scoop
to lessen spattering of hot oil.
Note:
If the plug accidentally detaches from the fryer during
operation, reattach the cord following step 6 above. Use extreme
caution as unit will be hot.
10. occasionally stir food gently, with scoop, while frying to prevent
foods from sticking together. Use scoop provided or other heat-resistant utensil.
11. When food reaches desired brownness, lift and drain with scoop. Place food on absorbent paper. Season to taste.
Repeat steps 9, 10, and 11 for additional servings.
12.
Remove plug from wall outlet and then from deep fryer.
Allow oil to cool completely before removing divider from
deep fryer. Remove divider from unit prior to emptying oil.
Care and Cleaning
1. After unit and oil have cooled completely, cover fryer with storage lid, or remove divider if it was used and empty
cooking oil.
2. Wash fryer, divider, and scoop with warm water and mild detergent. Rinse thoroughly.
Never immerse fryer in water
or other liquid, or wash in dishwasher.
3.
Dry fryer completely.
even a few drops of water in the oil can super-heat and turn into a volatile steam that may
cause hot oil to spatter, boil over, or even erupt out of the deep fryer.
4. Do not use steel wool scouring pads or abrasive kitchen cleaners on the nonstick finish.
5. occasionally clean the interior of unit with a commercial cleanser designed for nonstick surfaces, such as dip-it*
destainer. Follow manufacturer’s directions.
6. Periodically check the screws on the two handles to be sure they are tight. Retighten, if necessary, with a standard
slotted screwdriver. CAUTIoN: overtightening can result in stripping of screws or cracking of handles.
7. Store the cord in a clean, dry location away from metal objects. Always check the magnetic plug before use to assure
metal items have not become attached.
*dip-it is a registered trademark of ecolab, Inc.
electrical pins
Fig. B
Recessed
area
Magnetic
plug end
Fig. C For proper connection, the magnetic plug
end must be parallel with the countertop.
Correct
Position
Incorrect
Position
