Presto Lifts Power Stak PPS3000-125FS, Инструкция по установке, эксплуатации и обслуживанию

Страница: 6 / 29

PRESTO OWNER’S MANUAL Page 6 POWER STAK PPS3000-125FS
used for shipping purposes.
Check to see if chains are in place, and that the lift system is
in working order. Inspect for oil leaks.
See instructions for removing back panel on pg. 5.
Connect battery cable. Check cables and wires on battery
charger as well as battery.
S E C T I O N 4
OPERATION
A. OPERATING INSTRUCTIONS:
To Raise and Lower:
There are two buttons located on both sides of the handle.
The inside one is for raising the forks. The outside one is for
lowering the forks. When operating, always make sure the
load being lifted is within the loading capacity of your stacker
and the load has been stacked safely on the pallet. Also, make
sure that the length of the forks corresponds to the length of
the pallet. In this way, the load rollers will place themselves
in the opening at the end of the pallet, so that when you
raise the forks, you will not break the bottom boards of the
pallet. Always make sure that when entering the pallet that
the forks are in the fully lowered position. Be careful when
lifting pallets that are too short or too long for the stacker.
It might destroy your pallet by breaking the bottom boards,
and if the forks project through the end of the pallet, the tips
of fork may go into the next pallet that is behind the pallet
that you are lifting, which may bend the tips of forks and
overload the capacity of the stacker.
To Travel:
To travel, rotate the butterfly controls throttle on the upper
part of the handle. When rotating the butterfly control CW
towards the forks, the stacker runs forwards in the forks first
direction. When rotating the butterfly CCW towards you, the
stacker runs backwards in the handle first direction. Always
make sure the stacker clears any obstruction when travel-
ing, and that your path of travel is clear of people. Never
carry loads above the loading capacity of the stacker. It is
suggested that when traveling without a load, the forks be in
the lowered position. The speed of the stacker is increased
by the degree of the rotation in either direction; it functions
like a throttle. When you release your hand from the butterfly
control, it automatically will resume to the neutral position
and the speed of the stacker will slow down.
To Brake:
Your stacker is equipped with a magnetic brake. The brake
is applied when the handle is in its vertical position between
10 – 15 degrees and lowered position between 80 – 90 de-
grees. The brake could be released when you pull down the
handle at any point between 15 – 80 degrees. Always make
sure the brake is released before operating the stacker. When
the stacker is running, you could brake the stacker by raising
the handle to its vertical position or lowering the handle to
its lowest position. Or, to turn the butterfly controls in the
opposite direction, the change in direction of the motor will
slow down, stop, and reverse the direction of stacker.
When
parked , always put the handle in the full vertical position
with the brake applied and the forks in lowered position.
Figure 1: Operational buttons
BELLY BUTTON SWITCH
LIFT UP
LIFT DOWN
HORN
SPEED CONTROL
DIRECTION CONTROL