Presto Lifts
P4 Manual
9
4. Installation
Before Installation
read and understand this manual.
Only trained and/ or qualified personnel
shall install this machine.
Remove all packaging and inspect the machine for damage and/ or
missing components. Contact the manufacturer if damage is found or components are missing.
The owner/ installer is responsible for ensuring all codes and ordinances are met and any
necessary permits are obtained prior to installation.
Anchoring this machine is optional. Four anchor holes are provided if anchoring the machine is
preferred.
Electric motors can create sparking, do not install in an area where
flammable materials are present.
This machine must be installed in an area protected from rain and
moisture.
This machine must be installed and operated on a solid, level surface
capable of supporting the machine and it’s maximum rated capacity.
Do not sit, stand, or ride on the platform.
Fork trucks, pallet jacks, or other lifting devices used for moving this
machine must be capable of lifting 2000 lb. minimum.
Machines equipped with 1HP 115/1/60 power units must be powered
using a dedicated circuit with a 20 amp breaker.
Do not power this machine with an extension cord or the motor and
other electrical components may be damaged.
Do not enter beneath the platform.
This machine is shipped with two bolts threaded into inside of each side panel. These bolts allow
for the lifting of the machine.
To remove the machine from the shipping pallet:
1. Unfasten the machine from the pallet.
2. Plug the machine in and raise the platform until the vertical sides just come in contact with
the bolts.
Do not continue to power the machine after the platform contacts the
bolts or the machine may be damaged.
3. Unplug the machine and store the power cord so it does not get damaged during transport.
4. Carefully insert the forks of a fork truck under the platform and raise the forks until they
come in contact with the bottom of the
platform.
Insert forks completely
and ensure the
machine’s center of
mass is supported when
transporting.
5. Continue to carefully raise the forks until
the machine raises off of the pallet.
APPROXIMATE
CENTER OF
MASS
INSERT FORKS UNDER PLATFORM.
ENSURE FORKS ARE INSERTED
COMPLETELY AND MACHINE’S
CENTER OF MASS IS SUPPORTED
