Prestige PR1-D60, Инструкция по эксплуатации

Страница: 19 / 36

19
Important:
Before cleaning or carrying out any
maintenance disconnect the appli-
ance from the electrical supply and
wait for it to cool down.
Attention
The appliance gets very hot, main-
ly around the cooking areas. It is
very important that children are
not left alone in the kitchen when
you are cooking.
Do not use a steam cleaner
because the moisture can get into
the appliance thus make it unsafe.
ENAMELLED PARTS
All the enamelled parts must be cleaned
with a sponge and soapy water or other
non-abrasive products.
Dry preferably with a microfibre or soft
cloth.
Acidic substances like lemon juice,
tomato sauce, vinegar etc. can damage
the enamel if left in contact for too long.
STAINLESS STEEL, ALUMINIUM PARTS
AND SILK-SCREEN PRINTED SURFACES
Clean using an appropriate product.
Always dry thoroughly.
IMPORTANT: these parts must be
cleaned very carefully to avoid scratching
and abrasion. You are advised to use a
soft cloth and neutral soap.
CAUTION: Do not use abrasive
substances or non-neutral detergents
as these will irreparably damage the
surface.
WARNING
When correctly installed, your prod-
uct meets all safety requirements laid
down for this type of product catego-
ry. However special care should be
taken around the rear or the under-
neath of the appliance as these
areas are not designed or intended to
be touched and may contain sharp or
rough edges, that may cause injury.
REPLACING THE OVEN LIGHT BULB
Switch the cooker off at the mains .
When the oven is cool, unscrew and
replace the bulb with another one
resistant to high temperatures (300°C),
voltage 230 V (50 Hz), 15 W, E14.
Note: Oven bulb replacement is not
covered by your guarantee.
CLEANING
AND
MAINTENANCE
8
INSIDE OF OVEN
The oven should always be cleaned
after use when it has cooled down.
The cavity should be cleaned using a
mild detergent solution and warm
water. Suitable proprietary chemical
cleaners may be used after first consult-
ing with the manufacturers recommen-
dations and testing a small sample of
the oven cavity. Abrasive cleaning
agents or scouring pads/cloths should
not be used on the cavity surface.
NOTE : The manufacturers of this
appliance will accept no responsibility
for damage caused by chemical or
abrasive cleaning.
Let the oven cool down and pay
special attention no to touch the hot
heating elements inside the oven
cavity.
Do not use harsh abrasive cleaners or
sharp metal scrapers to clean the
oven door glass since they can
scratch the surface, which may result
in shattering of the glass.