Prestige APS-901E, Руководство по установке

Страница: 19 / 24

128-9300
19 of 24
19
The transmitters are pre-programmed from the factory, If you find you need to program new or additional
transmitters follow the instructions below.
PROGRAMMING BANK 1
(TRANSMITTERS):
1) Turn the ignition key to the on position.
2) Press and release the valet/programming switch 3 times (Siren Chirps Once).
3 Press the Lock Button of each transmitter you want programmed until you hear a chirp from the horn or siren.
4) Turn the ignition switch off. 1 Short followed by 1 Long Chirp indicates exit of programming mode.
The above action programs the Lock, Unlock, Start/Trunk, and Option 1 buttons of the system. For additional
channel programming see the owners guide found within the literature bag packaged with this kit.
PROGRAMMING BANK 2
(ALARM FEATURES):
You can enter bank 2 from bank 1 by turning the ignition key off then on from step 4 of Bank 1, you will hear
2 chirps, or You can also go right to bank 2 by:
1) Turn the ignition key to the on position.
2) Press and release the valet/programming switch 3 times (Siren Chirps Once).
3) Turn the ignition key off then on you will hear 2 chirps.
4 Press the pushbutton switch once to advance to feature 1, twice to advance to feature 2, etc,,,then use
the lock button of the transmitter to select the feature setting.
Example to set passive arming:
1) Turn the ignition key to the on position.
2) Press and release the valet/programming switch 3 times (Siren Chirps).
3) Turn the ignition key off, then on, Siren chirps 2 times.
4) Press the pushbutton switch six times to advance to features 6, Pass/Act Arm, then use the lock button
of the transmitter to select two chirps "Passive Arm".
5) To exit the programming mode, turn the ignition key off more than 6 seconds. Siren sounds a short chirp
followed by a long Chirp.
New: The chirp and LED patterns have been changed to make it easier to determine what feature you are
in. As well the feature bank will not time out until the ignition switch is off for more than 5 seconds.
The change will be noted when you get to feature # 11, the LED pattern will be 1 pause, 1,,#12 will
be 1 pause, 2, #13 will be 1 pause 3, #22 will be 2 pause 2, etc. This will make it eaiser for the
technician to determine what feature they are up to.
Feature Bank Reset: If you wish to reset a feature bank to the default settings, from within that bank, press
and hold the pushbutton on the receiver/antenna for 5 seconds or until a chirp/flash is heard from the sys -
tem. This action resets the feature bank. The feature banks are reset individually so resetting bank 2 will
not effect bank 3 & visa versa.