128-9316
6 of 16
Page 6
2 Light Green Wire:
(-) Instant Trigger Zone 1
This is a instant on ground trigger input intended for the connection of optional triggering devices. The
ground trigger output wire of motion detectors, microwave detectors, or glass break detectors, can be
connected to this Light Green trigger input wire.
3 No Connection, Empty Cavity
4 Brown Wire:
- Door Trigger
If the vehicle’s courtesy light switches have a ( - ) ground output when the door is opened (GM and most
Imports), you must connect this wire to the negative output from one of the door switches.
WARNING:
Do not use the brown wire if the vehicle has + 12 volt output type door switches.
(See Purple Wire). Note for vehicles with interior delay lighting see programming under
title Completing The Installation".
5 Dark Green Wire:
( - ) Instant Trigger Zone
This is an instant on ground trigger wire. It must be connected to the optional previously installed hood
and trunk pin switches when used.
6 Purple Wire:
+ Door Trigger
If the vehicle’s door courtesy light switches have a + 12 volt output when the door is opened (most Fords
and some Imports), you must connect this wire to the positive output from one of the door switches.
WARNING!
Do not use the purple wire if the vehicle has ground output type door switches. (see
Brown Wire). Note for vehicles with interior delay lighting see programming under title
"Completing The Installation".
7 Orange w/ White Trace Wire:
300 mA Ground Output When Disarmed - N. O. Starter Disable
( Optional Relay Required ).
This wire is provided to control the starter cut relay. Connect the orange w/white wire to terminal 86 of
the relay. Connect relay terminal 85 to an ignition wire in the vehicle that is live when the key is in the on
and crank positions, and off when the key is in the off position. (This is where the yellow wire from the
alarm should be connected ).
Cut the low current starter solenoid wire in the vehicle, and connect one side of the cut wire to relay
terminal 87. Connect the other side of the cut wire to relay terminal 30.
NOTE:
This is a normally opened starter cut arrangement, and when power is removed from the security
system, the starter disable feature will remain operational, and the vehicle will not start. Audiovox
does not recommend using the Orange w/White trace wire to interrupt anything but the starting
circuit of the vehicle.
8 Yellow Wire:
+ 12 VDC Ignition Source
Connect this wire to a source that is live when the key is in the on and crank positions. Be sure that this
source is off when the key is in the off position.
