128-9345
Page 5 of 8
Page 5
INTRUSION WARNING SIGNALS:
The system will inform you if an intrusion attempt has occurred while you
were away from the vehicle. If an intrusion attempt has occurred, the siren
will "chirp" 4 times when disarming the system.
The vehicle's parking lights will also flash 3 times to indicate an intrusion
has occurred. Enter the vehicle and observe the dash mounted LED for
further information.
1. If the LED is flashing one time... pause...one time... etc., then an intrusion
attempt was made to a light activated entry point, or the shock sensor
was activated.
2. If the LED is flashing two times...pause...two times...etc., then an intru
-
sion attempt was made to the hood, trunk, or an optional sensor that
has been connected to zone 2.
3. If the LED is flashing three times...pause...three times...etc., then an
intrusion attempt was made through one of the vehicle's doors.
These intrusion warning indicators are stored in the system's memory and
will only be erased from memory when the ignition key is turned on.
Push Button LED Valet / SYSTEM OVERRIDE Switch:
The "Valet" switch allows you to temporarily bypass all alarm functions,
eliminating the need to hand your transmitter to parking attendants or
garage mechanics. When the system is in valet mode, all alarm functions
are bypassed, however, the remote panic feature and remote door locks
(optional) will remain operational. To use the valet mode:
1. Enter the vehicle and turn the ignition key to the ON position.
2. Press and hold the LED valet push button switch for 5 seconds until the
LED turns on solid. The LED will remain on as long as the system is
in the valet mode.
3. To return to normal operation, with the ignition switch on, press and re-
lease the LED valet push button switch one time. The LED will turn off
indicating the unit has been returned to the normal mode of operation.
In the event you lose your keychain transmitter, or if the transmitter fails to
disarm the system, the valet switch can be used as a system override switch.
Open the car door (the alarm
will
sound). Turn the ignition key on, and
press and hold the LED valet switch on. The alarm will stop sounding, and
the vehicle can now be started.
