128-9345
Page 3 of 8
Page 3
ARMING THE SYSTEM: (ACTIVE)
1. Turn off the engine, exit the vehicle and close and lock all doors, hood
and trunk.
2. Press and release the Lock button on the keychain transmitter. The
siren will "chirp" once, the vehicle's parking lights will flash once, the
doors will lock (optional), and the dash mounted LED will begin to
slowly flash.
WARNING!
Excessive pressure on the transmitter buttons will damage the
internal components on the circuit board. All that is required
is a light push to the button.
NOTE:
If the siren "chirped" three times when Locked, then one of the
entry points (hood, trunk, doors) has been left opened. Closing the
hood, trunk, or doors will correct the problem and you do not need
to disarm the system to make the correction. If the siren "chirped"
three times, sometime after arming, the exclusive delayed dome
light learn circuit has been programmed and the system detected
a open entry point after the learned delay expired. Again, closing
the hood, trunk, or doors will correct the problem and you do not
need to disarm the system to make the correction.
ARMING THE SYSTEM: (PASSIVE)
1. Turn off the engine, exit the vehicle, close and lock all doors, hood and
trunk.
2. The dash mounted LED will begin to flash rapidly, indicating that the
system is automatically (passive) arming. As an added convenience,
the automatic passive arming will not begin until all doors and trunk lid
are closed, allowing passengers to exit the vehicle at their convenience.
3. In 30 seconds, you will hear a single short "chirp" from the siren and
the vehicle's parking lamps will flash one time, indicating the system is
ARMED. At this time, the dash mounted LED will begin to flash slowly,
providing a visual indication that the system is fully ARMED.
OPTION NOTE:
If the optional (not included) power door lock interface
has been installed, the alarm control module can be
programmed to:
