PRESIDENT Bill ASC, Руководство пользователя

Страница: 26 / 40

26
9) USB CHARGING SOCKET
The USB socket ( 9 ) can be used to charge a smartphone,
tablet or other rechargeable device with 5 V - 2.1 A.
10) 6 PIN MICROPHONE PLUG
The plug is located on the front panel of the transceiver
and makes the setting of the equipment into the dash-
board easier. The BILL ASC accepts electret or dynamic
microphone (see menu MIC TYPE on page 28) .
See cabling diagram page 37.
11) PTT (Push To Talk)
Transmission key, press
PTT
switch to transmit a message,
is displayed and release to listen to an incoming
communication.
TOT (Time Out Timer)
If the PTT switch ( 11 ) key is pressed for more than 3 minutes,
the display starts blinking and the transmission ends.
A beep will sound until the
PTT
switch (
11
) key is released.
C) FUNCTIONS TURNING ON THE UNIT
2 additional functions are available.
FREQUENCY BAND
SELECTION
,
F
key (
5
) and the
MENU
mode,
AM/FM
key
( 7 ).
To activate a function, first turn off the unit. Then turn on
the radio while pressing the corresponding key ( 5 ) or ( 7 ).
1) F -
FREQUENCY BAND SELECTION
(
F
key)
(Configuration: EU; PL; d; EC; U; In)
The frequency bands have to be chosen according to the
country of use. Don’t use any other configuration. Some
countries need a user’s licence. See table page 39.
1.
Turn on the power while pressing the
F
key (
5
). The letter
corresponding to the current configuration is blinking.
2. In order to change the configuration, use the
s
/
t
keys
( 3 ) on the unit or the UP / DN key ( 3 ) on the microphone.
3.
When the configuration is selected, press the
F
key (
5
) 1
second. The letter corresponding to the configuration is
continuously displayed and a confirmation beep sounds.
4.
At this point, confirm the selection by switching off the
transceiver and then switching it on again.
See the frequency bands table at pages 34 to 36 /
configuration table page 38.
2) MENU MODE
(
AM/FM
key)
1.
Turn on the radio while pressing the
AM/FM
key (
7
) to
enter into the
MENU
mode. appears.
The order of the 6 menus is the one described in this
manual. However, the menu displayed when entering
the
MENU
mode will be the last menu edited by the
user.
Whatever the menu, the procedure is the same:
2
. Use
s
/
t
(
3
) on the unit or
UP
/
DN
(
3
) on the microphone
to select the menu to be set.
3. Press the F ( 5 ) key to confirm the chosen menu. The
parameter of the menu blinks in the display.
4. Use
s
/
t
( 3 ) on the unit or UP / DN ( 3 ) on the microphone
to select the parameter value.
5.
Press again the
F
(
5
) key to confirm the value of the chosen
parameter. The parameter stops blinking and, if the function
has more than one parameter, then the next parameter
blinks. Start again at point 2 to set another menu or...
English