ENGLISH
8
QK81C
Installation (continued)
INSTALLING THE SINK
NOTE: Install the strainer according to "Installing the Strainer" instructions
before completing this step.
-
Press fit the threaded anchor inserts into the holes drilled into the underside of the countertop. Use a bolt to
make this process easier if required .
- Loosely thread the undermount bolts and clips into the threaded anchor inserts and align them parallel to the
sink flange outline so they do not interfere with the placement of the sink.
-
Place a small bead of silicone sealant (not included) around the outer top perimeter of the sink flange as
shown below .
-
Carefully place the sink (A) into its location under the counter, lining up the sink with the sink flange outline.
-
Carefully rotate the clips over the sink flange and gently tighten the bolts (see tightening sequence) to fasten
the sink. Recheck the alignment visually from above and make final adjustments if necessary, then tighten all
the bolts .
- Wipe away any excess silicone and, for best results, allow the bond to rest undisturbed for 8 hours .
- Install faucet, soap dispenser, and sink strainer as per instructions in this manual .
- Install all other plumbing as per manufacturer’s instructions .
A
A
9
6
2
4
3
5
1
7
8
10
Tightening sequence for clips
Bolt
Silicone
Sealant
Threaded
anchor inserts
Counter
Clip
Fig . 4
