Premium PAC247C-I, Руководство по обслуживанию

Страница: 64 / 68

Wireless Remote Controller MLCAC-UTSM-2011-02
62 Control
Buttons and functions
1. Adjust
: Decrease the set temp. Keeping pressing will decrease the temp with 1
℃
per 0.5s.
2. Adjust : Increase the set temp. Keeping pressing will increase the temp with 1
℃
per 0.5s.
3. MODE : Once pressing, running mode will be selected in the following sequence:
AUTO COOL DRY HEAT FAN
NOTE: No heating mode for cool only type unit.
4. DIRECTION/VERT SWING: Used to stop or start horizontal louver movement or set the desired up/down
air flow direction. The louver changes 6 degree in angle for each press. If keep pushing more than 2 seconds,
the louver will swing up and down automatically.
5. HORIZ SWING: Used to stop or start vertical louver movement.
6. RESET (inner located): Press this button with a needle of 1mm to cancel the current setting and reset
remote controller.
7. ON/OFF : For turning on or turning off the air conditioner.
8. FAN SPEED: Fan speed will be selected in following sequence once pressing this button:
AUTO LOW MED HIGH
9. TIME ON: For time ON setting. Once pressing this button, the time will increase by 0.5 hour. When the set
time exceeds 10 hours, pressing the button will increase the time by 1 hour. Adjusting the figure to 0.00 will
cancel time ON setting.
10. ECO: Activate or turn off economic operation mode. It is suggested to turn on this function when sleeping.
(Only available when remote controller is used with corresponding unit.)
11. TIME OFF: For time OFF setting. Once pressing this button, the time will increase by 0.5 hour. When the
set time exceeds 10 hours, pressing the button will increase the time by 1 hour.
Adjust the figure to 0.00 will cancel time ON setting.
12. CLOCK: Display the current time. (12:00 is displayed when resetting or electrifying for the first time.)
Press CLOCK for 5s, icon indicating hour will flash with 0.5s. Press it again; icon indicating minute will flash
with 0.5s.
and are used to adjust the figure. Setting or modification is effective only by pressing OK
button to make confirmation.