Page 4
BO
TTO
M
BO
TT
OM
- DIN REAR-MOUNT (METHOD B)
Installation using the screw holes on the sides of the unit.
Fastening the unit to the factory radio mounting bracket.
1. Select a position where the screw holes of
the bracket and the screw holes of the main
unit become aligned (are fitted) and tighten
the screws at 2 places on each side.
2. Screw
3. Factory radio mounting bracket.
4. Dashboard or Console
5. Hook (Remove this part)
Note: the mounting box, outer trim ring,
and half-sleeve are not used for method B
installation.
5
2
4
3
2
5
a. Frame
b. Insert fingers into the groove in the front of frame and pull
out to remove the frame. (When re-attaching the frame,
point the side with a groove down wards and attach it.)
c. Insert the levers supplied with the unit into the grooves at
both sides of the unit as shown in figure until they click.
Pulling the levers makes it possible to remove the unit
from the dashboard.
- Trim Plate Installation:
Removing the unit
a
b
c
- PANEL OPEN/CLOSE OPERATION
1
C
D
IN
RE
SET
2
1. Press Open button
2. The CD slot will be accessible.
3. After CD is loaded or unloaded return the panel to its original position.
Before attaching the trim plate, the side with a "Bottom" Label stuck
should be at down side (as shown on diagram).
Push the trim plate against the main panel until it is fitted.
Page 5
3.DETACHABLE CONTROL PANEL (D.C.P.)
Removing The Detachable Control Panel (D.C.P.).
CAUTION
DO NOT insert the D.C.P from the left side. Doing so may damage it.
The D.C.P can easily be damaged by shocks. After removing it, place it in a protective case and be careful
not to drop it or subject it to strong shocks.
When the release button is pressed and the D.C.P is unlocked, the car's vibrations may cause it to fall. To
prevent damage to the D.C.P, always store it in a protective case after detaching it.
The rear connector that connects the main unit and the D.C.P is an extremely important part. Be careful not
to damage it by pressing on it with fingernails, pens, screwdrivers, etc.
Note:
If the D.C.P is dirty, wipe off the dirt with soft,
dry cloth only. And use a cotton swab soaked
in isopropyl alcohol to clean the socket on the
back of the D.C.P.
Socket
1. Turn the Power off.
2. Press the Panel Release Button.
3. Remove the D.C.P.
Attaching the Detachable Control panel (D.C.P.)
1. Insert the right side of the
D.C.P. Into the main unit.
NOTE: The D.C.P. Must be
attached into the T-Joint.
2. Press the D.C.P. On to the
left side of middle of D.C.P.
Until a “click” sound is heard.
2.
1.
RELEASE
BUTTON
D.C.P.
PU
SH
