Premier MCO-5199, Инструкция по эксплуатации

Страница: 33 / 36

P-14
4. Stop when the sewing is conducted to the end mark, rotate hand wheel and stop the sewing needle at
the bottom right;
Sew button hole by inserting thread
After button hole is sewed, take out cloth, open in the middle of
cloth by button hole scissor. Do not cut sewed thread
negligently.
1. Put inserting thread in the presser foot as shown in the figure;
2. Sew the inserting thread inside during sewing and
3.Take out cloth stress the inserting thread and cut thread.
Tips: It is preferential to firstly exercise by some scraps for
sewing button hole; it could be begun until the sewing
results are satisfied;
Button Attaching
1. Mount feed cover plate (Fig 1);
2. Replace presser foot for button attaching
(Fig 2);
3. Select a zigzag pattern approximate to
space of button holes (Fig 3);
4. Put button under the presser foot and make
left and right positions of needle respectively
face the left and right button holes (Fig 4);
5. If it is necessary to extend thread pitch of
button attaching longer (Fig 5), one needle
could be put on the presser foot (Fig 6);
6. Sew about 5 stitches and leave 20cm
thread end, wind it on thread pitch, and then
cross it to the back and tie a knot (Fig 7)