P-5
Operation with rechargeable batteries
1. Open the battery compartment on the rear side of the receiver.
2. Insert the battery pack, and connect it with the socket. The connector can only be fitted one
way.
3. Close the battery compartment again.
The receiver is powered by a a Lithium-ion battery pack of 3.7 V, 1500 mAh. The rechargeable
battery pack can be recharged directly in the receiver when it is inserted in the charging station.
The Power LED lights up when the receiver is being charged. In the case of a low battery
charge, the Power LED flashes slowly. The battery pack must then be
recharged.
Mounting/dismounting the belt clip
Prize the latch (see figure) with a suitable tool (such as a small
screwdriver) a little bit away from the chassis and move the belt clip
down simultaneously. To attach the belt clip slide it into the guide
towards the top until it snaps in.
Optimization of range
Baby unit and parent unit come with fold-out antennas. If
necessary, optimum range can be achieved if both the Baby
unit and Parent unit antennas are extended vertically.
O
PERATING THE
T
RANSMITTER
Switching the transmitter on/off
Position the transmitter
in a good position for the monitoring tasks required
and align
the camera lens to the area to be monitored.
Slide the switch to ON. The Power LED lights up.
The transmitter is now ready to operate.
To switch the unit off, slide the switch to OFF.
In the case of a low battery voltage, the Power LED flashes slowly.
In this event replace the 4 x AAA batteries with fresh alkaline cells.
