PREMIER WINCH DV-12 light, Руководство пользователя

Страница: 7 / 21

7
DV-6000S DV-9000i
DV- 9000ES / DV-12 light
DV-12000ES/15000ES

Switch Connection
1. A hand-held remote switch withψ2.0mm X 3c X
3m/ψ1/12” X 3c X 10’ cord supplied
2. Open the dust-proof cover of the winch, then
insert the switch plug into the socket (fig4).
IV. Operation

Precautions
C heck all safety and environmental conditions prior and during use.
A wire rope should be replaced if it shows signs of excessive wear, broken wires, corrosion or
any other defect.
The operator must remain with the winch when it is being operated.
The winches duty rating is S3 (intermittent – periodic)
If the winch fails to pull a load under normal conditions, stop the operation within 30 seconds
otherwise motor damage may occur.
Ensure that the winch is connected to the correct voltage. 12VDC or 24VDC only
Check that
the clutch lever is in the “Engaged” position during and after use.
Remove the pendant from the winch when not in use.
Do not wrap the wire rope around the load and back onto it self. Always use a strap to ensure
that the wire rope does not fray or kink
Keep hands and clothes away from the winch, wire rope, and fairlead.
Never unplug the pendant when winching a load.
Before use, ensure that you are familiar with all winch operations (winch speeds & direction).
To avoid insufficient power when winching a load, the vehicle should be running and in
neutral.
Keep the pendant cord clear of the winch cable at all times.
If noise or vibration occurs when running, stop the winch immediately and return it for repair.
(Fig4)