Premier Pet GPA00-16344, Руководство по эксплуатации продукта

Страница: 5 / 12

premierpet.com 5
Key Definitions
Outer Frame Size: Overall pet door dimensions
Cut Out Size: Opening cut in homeowner’s door for proper fit and pet door installation
Replacement Flap Size: Overall flap size when removed from pet door. During extreme changes in
weather, vinyl flaps can shrink during cold months and stretch in warmer months
Flap Opening Size: Usable flap size for pet to enter and exit through pet door
Interior Frame: Pet door frame on the inside of home
Exterior Frame: Pet door frame on the outside of home
Snap-on Closing Panel: Cover that snaps onto the pet door frame to close the pet door opening
Installing Your Pet Door
NOTICE
If painting the pet door, it is recommended to paint it prior to the pet door being installed.
For best results, use a primer for plastics before applying your paint.
Step 1
Determine Pet Door Location
1A Measure and mark your pet’s shoulder height on the interior side
of door.
1B Determine location for the pet door. Draw a vertical center line
through the shoulder height line using a level.
Step 2
Prepare Door
2A Remove door from hinges.
2B Place on a raised level surface such as saw horses.
Helpful Tip: Clamp or weigh down the door to prevent it
from moving.
Note:
The Pet Door can be installed with the door hanging
based on your skill level.
2C Cut out the correct template size. Match the marked lines
on the door with the shoulder and center lines on the template.
Tape the template in place and carefully trace template. Make
sure to trace underneath tape and connect the corners. Now,
remove the template and any excess tape from the door.
1A
1B
NOTICE
If homeowner’s door or other application is not level,
the pet door must be marked level to swing properly.
2A
2B
NOTICE
When applying cutting template there should be a
minimum of 3” between the bottom and sides of the
door and the outer edge of the cutting template to
maintain the structural integrity of the door.
3
”
min.
(76mm)
3
”
min.
(76mm)
3
”
min.
(76mm)
2C