Premier Pet GDT00-16298, Руководство пользователя

Страница: 4 / 8

+1 (866) 381-2785 4
Charge the Collar and Remote
Excessive charging can shorten battery life. Only charge your remote or collar when the batteries are low.
1. Lift the cover protecting the charging port and connect the charger to the collar and/or remote.
2. Plug the opposite end of the charger into a compatible charging port.
3. Plug in and fully charge the remote and the training collar. The battery icon on the remote will cycle
while charging and then remain solid when it is fully charged. The LED on the training collar will be
solid red when charging and will turn off when the training collar is fully charged.
4. When the training collar and remote are charged, replace their rubber covers. The mud plug covering
the charging port must be in place for the collar to be waterproof.
NOTE: The remote is always on, and the display will appear when any button is pressed.
Turn the Collar On/Off
To Turn the Collar On
Press and hold the On/Off button until you hear a beep. The LED will give one quick flash then flash once
every 5 seconds (every 3 seconds when the battery is low).
To Turn the Collar Off
Press and hold the On/Off button until the training collar beeps, and then release. The training collar
turns off.
Quick Tip: When you are not using the collar, you will want to turn it off. This will increase the battery life.
Test the Collar
To test the collar, ensure that the remote is paired with the collar and the
remote shows Dog 1. Then press the test light tool against the contact
points on the collar, and push the action button on the remote while in
static mode. The test light should flash.
Two Dog System
If you wish to add another collar to the training system, an Add-A-Dog
®
collar is available for purchase
through our Customer Care Center.
Add-A-Dog
®
Pairing
With the purchase of a Premier Pet
™
Add-A-Dog
®
training collar, this remote can be paired with two
collars. Ensure that the remote is on the correct Dog 1/2 setting when pairing a collar, and follow the
steps above.
1. Turn the collar off.
2. Press and hold the on/off button. The LED light will turn on, then off in 4-5 seconds.
3. After the collar LED has turned off, release the on/off button.
4. With Dog 2 selected on the remote, press and hold any button on the remote until the collar LED light
flashes 5 times.
5. Pairing is now complete and the trainer is ready to use.