UNI-SPKR/UNI-SPKRB
Page 6
Visit the Premier Mounts website at http://www.premiermounts.com
Installation Instructions
The UNI-SPKR kit comes with 18 AWG speaker wires
pre-installed. If you would like to replace the wires, follow
these instructions.
Remove the six (6) 4-40 x 1/4” Phillips flathead
screws from each back cover of the speakers.
®
Remove the back covers, gaskets and old wires
from the speakers.
¯
Use an 18 AWG wire stripper to strip off the
insulation from the new speaker wires by 3/16”.
°
For each new wire, twist the ends of the wire
strands together.
±
Attach the new speaker wires to the speaker
terminals.
²
Knot each pair of speaker wires just inside the
inner slots in the speaker housing.
This will prevent the wires from accidentally
pulling out when you attach them to the amp.
²
Thread the wires through the inner slots of the
speaker housing (see drawing).
³
Re-attach the gaskets and back covers with the
back cover screws.
Do not overtighten the back cover screws.
w
Step 3
Amp Receptacle for the
Captive Screw Plug
Insert the four wires from the speakers into the blue
4-pin captive screw plug supplied with the power
amp.
Use a #1 Phillips screwdriver to tighten the
locking screws.
Match the wiring polarity. For example, red for
positive, black or white for negative.
Make sure no wire strand bridges (shorts) the
adjacent terminals.
®
Insert the captive screw plug into the receptacle on
the amp’s rear panel (see drawing).
Proceed to the
“Installing the Power Amp (sold
separately”
section.
Step 2
Inner Slot of Speaker
Housing
