RTM-S
Installation Instructions
Page 9
Universal Mounting Bracket Assembly
1. Place the universal bracket bar and the universal brackets on a flat surface.
2. Slide the universal brackets onto the universal bracket bar (as shown below) with the set screws facing
up. At this time, do not tighten the set screws that are located on the universal bracket.
3. Place the display on a soft, flat surface, face-down. Next, place the universal bracket assembly on the
back of the display, with the universal brackets resting directly over the display mounting points.
4. Once the desired position has been determined, place the Griplate™ washers over each mounting point
and secure them using the appropriate hardware (see Page 5).
NOTE
: For the two upper mounting points, the Griplate™ flat side must be facing up. For the two
lower mounting points, the Griplate™ flat side must be facing down.
5. At this time, center the universal bracket bar and tighten the set screws that are located on the universal
brackets.
M4 M5 M6 M8
WARNING:
THE CONGFIGURATION THAT THE UNIVERSAL MOUNTING BRACKETS
ARE IN ABOVE MUST REMAIN THE SAME. ANY DEVIATION FROM THE
LAYOUT ABOVE COULD AFFECT THE OPERATION OF THE MOUNT.
WARNING
: IT WILL TAKE TWO PEOPLE TO COMPLETE THE NEXT INSTALLATION
STEP.
Griplate™
U n i v e r s a l
Bracket Bar
Set Screw
Universal Mounting Brackets
Griplate™
Griplate™
