PTM-B
Installation Instructions
Page 7
For the PTM-B, it is suggested that the
mount and adapter plate be attached to the
display while the display is on the ground.
The reason for this is because once the
display is attached, there is limited space
behind the unit to use a screwdriver to
tighten the screws.
UFP-200 Adapter Plate
Use six (6) M4 x 10mm screws to attach the plate to the
display ( - 6 total).
Install the top two M4 x 5mm screws into the UFP-200
plate. Do not thread tight.
Attaching the Display
1. Loosely tighten two (2) M4 x 10 phillip screws to the top of the mounting points.
2. Insert the head of the screws through the keyhole slots and then secure the bottom two (2) M4 x 10 phillip screws to
secure the flat panel to the mounts, then tighten the upper M4 screws.
CAUTION
: Do not over tighten the M4 screws.
Display
M4 x 10mm
Phillips Head
Screws
M4 x 10mm
Phillips Head
Screws
VE
S
A
7
5
1.
Attach the UFP-200 Adapter Plate to the back of the display
using the six (6) M4 x 10mm screws.
2.
Attach the PTM mounting plate to the back of the
UFP-200 using the four (4) M4 x 5 mm screws.
NOTE
: If your flat panel is not a VESA 75/100, the UFP-200
Adapter Plate must be used.
CAUTION
:
DO NOT OVERTIGHTEN THE SCREWS.
M4 x 10mm Phillips
Head Screws
M4 x 5mm
Phillips Head
Screws
