Page 6
Installation Instructions
PTM-B
PTM Installation
1. The reverse side of the mount must be mounted to the back
plate that is attached to the wall. The back of the mount
contains an elongated rectangle. The back plate
receptacle must be placed over the top of the back plate, so
that the entire mount “hangs” on the back plate.
2. Locate the access hole at the bottom of the mount base. Install
the M6 x 35mm set screw with the M3 Allen wrench.
3. Turn the Allen wrench clockwise (viewed from below) until
the screw is secure.
WARNING
: Failure to fully tighten the locking screw may
result in possible damage to your display.
PTM Tension Adjustment
To adjust the tension of the PTM, use
the 14mm socket and Allen Wrench.
The tension nut is located on the face
of the PTM.
Use the M3 Allen Wrench (supplied) to tighten the
locking screw that is located on the bottom of the
mount base. This locking screw will prevent the
mount and display from being lifted off of the wall
plate.
M3 Allen Wrench
