PTDM2
Installation Guide
Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids
www.mounts.com | North America 800.368.9700 | Interna1-714-632-7100
Page 10
Attaching the Flat Panel to the Wall Plate
This section requires two people.
Do not release your flat panel until you are
certain that top and bottom hooks of both
mounting brackets are securely seated on
the upper and lower mounting rails of the
wall panel.
n
n
Raise the flat panel past the top and bottom
mounting rails on the wall panel.
n
o
Slide the flat panel down slowly, keeping it
close to the wall.
n
p
Engage the top and bottom mounting
brackets to the rails of the wall plate.
Proceed to the “Mounting Bracket
Adjustments” section.
Mounting Bracket Adjustments
M6 x 35mm
Locking Screw
(1 per Bracket)
M6 x 30mm
Leveling Screw
(1 per Bracket)
If your flat panel is tilted too far to one side, the leveling
screws will allow you to compensate for this tilt by
simply adjusting the screws with a screwdriver.
n
n
Loosen both locking screws.
n
o
Adjust the tilt of your flat panel.
n
p
Tighten both locking screws.
Caution!
It is possible to dislodge your flat panel while you
level your flat panel. Use extreme caution until
you tighten the locking screws.
After you have finished leveling your flat panel, be sure
to tighten the two (2) M6 x 35mm locking screws.
Do not overtighten the locking screws.
Leveling Screw Adjustment
Locking Screw Adjustment
