PSD-EB
Assembly Manual
Page 8
Installing the Plasma to the Stand
CAUTION
: The flat panel display is very heavy. Two people are required to safely lift the flat panel and
secure it to the back plate installed on the stand.
NOTE
:
To install the PSM-Series or CTM-Series mounting brackets to the flat panel, refer to its installation
instructions.
The flowing diagrams show the CTM and PCM series systems.
PSM-Series
: Raise the flat panel display with the mounting bracket secured. Insert the four (4) tab openings
from the PSM mount to the four (4) receiving tabs found on the PDB-UWFB back plate. Push to
slide the flat panel display down, right and down again to lock the mounts together (Figure 3).
Make sure all tab openings are interlocked with the receiving tabs before letting go of the flat
panel. Secure the brackets with the two (2) M6 x 12 (mm) Phillip (supplied) screws for
additional security.
CTM-Series
: Raise the flat panel display with the left and right brackets secured to the plasma and insert the
bottom and top hooks from the mounting arms to the top and bottom rods found on the CTM
back plate. Secure the mounting arms with the two (2) M6 x 12 Safety knobs (supplied).
CAUTION
: The safety knobs MUST be used. Failure to do so may result in damage to the flat panel display
or personal injury (Figure 3).
Figure 3
PSM Back
Plate
Flat Panel
Display
PSM-Series
Mounting
Brackets
M6 x 12mm
Security Screws
(4ea)
CTM-Series
Mounting
Brackets
Flat
Panel
CTM Back
Plate
M6 x 12mm
Safety Knobs
(2ea)
1
2
3
PSM-Series
CTM-Series
