THE EXACT CENTER OF THE STUD MUST BE LOCATED FOR CORRECT AND SAFE INSTALLATION.
Use an electronic stud finder (not supplied) to
locate the center of the stud that is in the wall.
Wood Stud
Stud finder
Wood Stud
Marking
UNI-GB
Do NOT over-tighten lag bolts when attaching the mount to the wall. Improper installation may result in personal
injury or damage to property.
Wood Stud Installation
Step 1
Step 2
Use a pencil to mark the first mounting point on the stud.
This will approximately be the height of the UNI-GB.
Step 3
Use the level to make sure the UNI-GB is level from
side to side.
®
Place the UNI-GB over the first mounting point mark
and use a pencil to mark the rest of the mounting
points.
Four (4) mounting points must be used. Two (2)
upper mounting points and two (2) lower mounting
points.
Mounting Point
Mark
Are you attaching the UNI-GB to wood studs or directly to the drywall?
If
wood studs,
continue to the
“Wood Stud Installation”
section below.
If
drywall,
go to the
“Dry Wall Installation”
section on page 6.
Determining the Type of Installation
Installation Instructions
Visit the Premier Mounts website at http://www.mounts.com
Page 5
UNI-GB
