Page 10
Installation Instructions
Step 1.
Activate the remote and extend the lift
until the lift is in the fully raised position.
Step 2.
Place the mounting spacer on top of the
lift.
Step 3.
Use four (4) M6 x 20mm Phillips flat head
screws to secure the spacer to the lift.
Mount Installation
Cabinet
Lift
Mounting
Spacer
Step 5.
Place the display mount on top of the lift
column.
Lift
Display
Mount
Screwdriver
M6 x 20mm
Mounting
Screw
Be sure to line up the holes on the
display mount with the threaded holes
that are located on the lift.
Side Slide
Bracket
L180F
Step 6.
Loosen the six (6) M6 x 12 screws on the
inside of the sliding support bracket.
Step 7.
Raise the bracket up to the desired height and
re-tighten.
Step 8.
When the lid and slides are inserted, the lid
should be sitting no less then ¼” above the
top of the display.
Step 9.
To gain extra height out of the slide support
bracket, use the top four (4) screws only.
This will allow the slide support brackets to
be raised higher.
M6 x 12mm
Mounting
Screw
M6 x 20mm Phillips
Flat Head Screws
Step 4.
Attach the slide brackets to the display
mount using twelve (12 - six per side)
M6 x 12mm Phillips head screws.
Slide Bracket
Display Mount
M6 x 12mm Phillips
Head Screw
Screwdriver
