GB-AVSTOR5
Installation Instructions
Visit the Premier Mounts website at www.mounts.com
Page 11
➊
Insert four (4) M5 x 8mm Phillips head screws loosely
into the outer holes inside the GB-AVSTOR5 (Figure
1).
➋
Place the mounting tray into the middle section of the
GB-AVSTOR5 (Figure 2).
➌
Hook the mounting tray onto the heads of the M5
x 8mm Phillips head screws on the GB-AVSTOR5
(Figure 3).
➍
Insert two (2) M5 x 8mm Phillips head screws into the
middle mounting holes of the mounting tray.
➎
Use a Phillips tip screwdriver to tighten all six (6)
screws.
Continue to
Ceiling NPT Adapter Plate Adjustment
on
page 12.
Do not overtighten the mounting screws.
Attaching the Mounting Tray to the GB-AVSTOR5
Zip Tie
➊
Place your electronic components onto the mounting
tray.
➋
Align the electronic components so that the weight is
distributed as evenly as possible.
➌
Run the zip ties through the mounting slots on the
tray, underneath the mounting tray and up through
the mounting slot on the other side of the electronic
component.
➍
Tighten the zip tie down and cut off any excess zip
tie.
Mounting Tray
As a reminder, small screws and flat washers may
also be used and are strongly recommended.
Attaching Equipment to the Tray
Mounting Tray Installation
For ease of installation, the mounting tray comes packaged in a separate box within the master carton.
Installers may pre-wire the mounting tray prior to the GB-AVSTOR5 ceiling box installation. Zip ties (included),
small screws and flat washers are strongly recommended to hold all equipment in place.
Figure 1
Figure 2
Figure 3
M5 x 8mm Phillips
head screw
Inside view of GB-AVSTOR5