ECM-3763T
Installation Instructions
Visit Premier Mounts website at http://www.mounts.com
Page
9
Removing the Locking Nut
Locking Nut
Mount Clamp
Locate the locking nut on top of the mount clamp.
An adjustable wrench may be used to loosen the
locking nut if it is too tight.
Remove the locking nut and and set it to the side.
Proceed to
“Determining the Mount Placement”
section.
Adjustable
Wrench
Determining the Mounting Placement
Proceed to the
“Eliptical Tilt Mount Installation”
section.
63
˝
fl
at panel shown above.
Do not use different size
fl
at panels with the
ECM-3763T. If one 63
˝
fl
at panel is used, the
remaining two
fl
at panels must be 63
˝
as well.
Different size
fl
at panels will cause unequal weight
distribution.
Please refer to the illustration to the right for
mounting placement.
Measure the distance between the mount arm
braces.
Divide this measurement by 2.
Measure directly out from the junction point of the
mount to the outer ring.
Mark this location, as the mounting clamp will be
attached at this marking.
Repeat through for the remaining mount
placement points.
Mount Arm
Brace
Junction Point
Outer Ring
Marking
1
4
