ECM-3763Q
Installation Instructions
Page 7
Selecting the Mounting Hardware
The optional M3
fl
at washers may be used to
decrease the screw depth of either the M2.5 x
12mm screws or the M3 x 16mm screws. Decrease
the screw depth by placing an M3
fl
at washer inside
the leveling barrel and then inserting the mounting
screw.
Selecting the Mounting Hardware
Insert a small straw or toothpick into the threaded
inserts found on the
back
of the
flat panel
.
®
Use a pencil to mark the depth of the threaded insert
on the small straw or toothpick.
¯
Mark the straw or toothpick 1/8” above the depth of
the threaded insert, as shown in Figure 1.
°
Insert the small straw or toothpick into the remaining
threaded inserts to compare and verify their depth
using the straw or toothpick’s 1/8” allowance mark.
±
Locate the correct diameter screw for the threaded
insert.
If the screw you selected is longer than the 1/8”
allowance mark on the small straw or toothpick,
as shown in Figure 2 and Figure 3, do not use this
screw. The screw length must not bypass the mark.
²
Test each size of the screws provided.
The correct screws should thread easily into the
mounting point and not pull out when tension is
applied.
Small Straw or Toothpick
Small Straw
or Toothpick
Small Straw
or Toothpick
Marking the 1/8”
Allowance
Depth Plus 1/8” Allowance
Mark
Depth Plus 1/8” Allowance
Mark
