Inverted
Projector
Figure 1
Figure 2
Figure 3
Thread Depth
Indicator
Thread Depth
Indicator
Depth Mark
Depth Mark
Thread Depth
Indicator
Threaded
Insert
Marking the
Depth
Screw
Screw
M8
M6
M5
M4
Warranty
: http://www.mounts.com/warranty
Garantie, Garantía, Garanzia, Garantie, Waarborg
Updates
: The most up-to-date installation
guides can be found at mounts.com
www.mounts.com | North America 800.368.9700 | Interna1-714-632-7100 | Europe +44 (0) 24 7664 4105
9531-000-001-0X Rev. 0
2
3
Installation Guide
Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids
ECM-3000
Premier Mounts’ Griplate™ Washers are designed to accom
-
modate the various M4, M5, M6 and M8 hole sizes required
by flat panels.
Do not place excessive pressure on the back of the flat
panel, as this may damage your flat panel.
The Griplate™ Washer must be installed between the head
of the mounting screw and the mounting bracket as shown.
Does your flat panel have:
Recessed mount points?
Uneven mount points?
A curved back?
Any obstruction near the mount point?
If Yes, you must install nylon spacers. Remove the mount-
ing brackets, Griplate™ washers, and mounting screws from
the back of the flat panel.
Insert the Thread Depth Indicator into the thread inserts
found on the bottom or top of the projector. Use a pencil to
mark the depth of the thread insert on the Thread Depth In-
dicator, as shown. Insert the Thread Depth Indicator into the
remaining thread inserts to compare and verify their depth.
Locate the correct diameter screw for the thread insert.
If the screw you selected is longer than the mark on the
Thread Depth Indicator, as shown in Figure 2 and Figure 3,
do not use this screw. The screw length must not bypass
the mark.
Select another screw length until you find a screw that
comes closest to the mark without going past the mark.
Test each size of the screws provided.
The correct screws should thread easily into the mount point
and not pull out when tension is applied.
The optional M3 flat washers may be used to decrease the
screw depth of either the M2.5 x 12mm screws or the M3 x
16mm screws. Decrease the screw depth by placing an M3
flat washer inside the leveling barrel and then inserting the
mounting screw.
