2
Contents:
Features Overview
1
Approvals
1
Safety information
2
Electrical Information
3
Fitting Information
3
In the box
3
Product description
4
Controller feature Function table
5
Wiring loom Information
6
Wire size vs distance selection matrix
6
Features
7
Ignition
7
Run
7
Interlock
7
Speaker output
7
Day and night volumes
8
Horn ring transfer (HRT) / Footswitch
8
Data output
8
Relay output (for horn bypass)
9
Relay output (for beacon control)
9
Sidelights input
9
PA
9
PLAY / REC
10
Radio Rebroadcast 1
10
Radio Rebroadcast 2
10
Fault LED
11
Circuit Protection
11
Typical installation diagrams
12
9005 with STC/ MTC
12
9005 with 8006 (RH button Air-horn)
14
9005 with 8006 (RH button beacon)
15
9005 with 8007
16
9005 with CP2 phase II
17
Troubleshooting
19
Safety Information:
Sirens are produced in 12 and 24 Volt versions. Ensure that you have the correct version for your
installation.
A suitable fuse and holder is provided with the siren amplifier wiring loom.
The recommended fuses are:
25A fuse for the 12V version
15A fuse for the 24V version.
The Siren amplifier should be installed by an electrically competent person in accordance with
the fitting instructions.
Any wiring to or from the siren should be sufficient to carry the load, loads are given on page 5,
there is also a wire size selection matrix which may aid this.
Sirens may get hot in use and they should be sited where this will not cause any hazards.
Consideration should be given to allowing air flow over the amplifier.
This equipment generates high levels of sound which may be detrimental to hearing. Care
should be taken during installation and testing so as to avoid endangering yourself or others.
Use of this equipment does not guarantee right of way over other road users and may not
always be heard by them. It should be operated only by trained and competent personnel.
D00217-00-A
REL: 39983
