4. Insert the two lower brackets into the holding holes on the heater.
5.
Hang the heater by fitting the two holes at the top of the heater onto the two upper
brackets. Loosen the upper brackets fixing screws, pull sliding bracket in the
lowest position and then tighten the brackets fixing screws.
G. OPERATING INSTRUCTIONS
Caution: This is heater is hot while in operation. It should not be operated
unless it is placed in an upright position. Remove all packaging material from
the heater.
1. Select an indoor location for the heater away from electrical power cords, curtains
and other furnishing. DO not place the heater directly beneath an electrical outlet
or against paperboard or low-density fibreboard.
2. Push the power switch to off and turn the thermostat to low before plugging in the
radiator.
3. Plug the heater into the power sockets and push the power switch to on.
4. There are two indicator light switches, which allow you to set your desired power
levels. ‘I’ is for 800W, ‘II’ is for 1200W. To set the third power setting, 2000W,
press both switches (II & I).
5.
There is an indicator light switch, which enables you to turn on/off the turbo fan.
“
” is for turning on the turbo, ”OFF” is for turning off the turbo.
6. The operating temperature is selected by adjustment of the thermostat.
7. To determine the correct operating temperature for you conditions, when
you first switch the unit on set the thermostat to the maximum position.
When the unit reaches the required temperature, slowly turn down the
thermostat, until the unit switches off. The temperature will now be kept
constant. When the temperature falls the unit will come on again.
H. SAFETY OVERHEAT SHUT OFF
A thermal overload protector is built in to prevent overheating. When a potential
overheat temperature is reached, the heater will be automatically shut off. It can
only resume operation when the user resets the unit.
I. RESET THE HEATER
1. Push the Power Switch to the
OFF
position.
2. Unplug the heater and wait 5-10 minutes for the unit to cool down.
3. Inspect and remove any objects on or adjacent to the heater that may
cause high temperature.
4. After 5-10 minutes, plug the unit in again and operate normally.
NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR HEATER, PLEASE
SEE THE WARRANTY FOR INSTRUCTIONS. PLEASE DO NOT ATTEMPT
TO OPEN OR REPAIR THE HEATER YOURSELF. DOING SO MAY VOID
THE WARRANTY AND COULD CAUSE DAMAGE OR PERSONAL INJURY.
J. CLEANING
Before cleaning turn the heater turn off and unplug from the power supply. To
clean use a soft cloth to wipe off any dust. If the heater is very dirty use a damp
cloth and wipe dry. Do not use any cleaning detergents, sprays or other
chemicals, as they will damage the heater. Store in the original packaging in a
ventilated dry area, during off season use.
Caution:
Do not allow water to run into the interior of the heater as this could
cause a fire or electric shock.
DO NOT
attempt to repair this heater yourself.
K. SPECIFICATIONS
Model
Power
Voltage
N.W. kg
G.W. kg
N10Turbo 2000W 230V~
50Hz 4.00
5.20
Loosen the upper brackets fixing screw,
pull sliding bracket in the lowest position,
and then tighten
the upper brackets fixing screw.
Brackets fixing screw
1
2
3
4
5
