4. Insert the two lower brackets into the holding holes on the heater.
5.
Hang the heater by fitting the two holes at the top of the heater onto the two upper
brackets. Loosen the upper brackets fixing screws, pull sliding bracket in the
lowest position and then tighten the brackets fixing screws.
G. OPERATING INSTRUCTIONS
Caution: This is heater is hot while in operation. It should not be operated
unless it is placed in an upright position. Remove all packaging material from
the heater.
1. Select an indoor location for the heater away from electrical power cords, curtains
and other furnishing. DO not place the heater directly beneath an electrical outlet
or against paperboard or low-density fibreboard.
2. Push the power switch to off and turn the thermostat to low before plugging in the
radiator.
3. Plug the heater into the power sockets and push the power switch to on.
4. There are two indicator light switches, which allow you to set your desired power
levels. ‘I’ is for 800W, ‘II’ is for 1200W. To set the third power setting, 2000W,
press both switches (II & I).
5.
There is an indicator light switch, which enables you to turn on/off the turbo fan.
“
” is for turning on the turbo, ”OFF” is for turning off the turbo.
6. The operating temperature is selected by adjustment of the thermostat.
7. To determine the correct operating temperature for you conditions, when
you first switch the unit on set the thermostat to the maximum position.
When the unit reaches the required temperature, slowly turn down the
thermostat, until the unit switches off. The temperature will now be kept
constant. When the temperature falls the unit will come on again.
24 Hour Programmable Timer
z
The heater will run continuously on when
the slide switch is in
TIMER
position (I).
z
The heater is turned off when the slide
switch is in
TIMER
position (0).
z
The timer operates when the slide switch
is in
TIMER
position (
).
z
To set the timer, rotate the clock dial
clockwise, until the current time is
aligned with the indicator arrow at the
centre.
When you wish the heater to switch ON, push the corresponding time segment
outwards from the centre. Each segment represents around 15 minutes. For
example, if you want the heater continuously ON for 2 hours, push 8 segments
out from the centre face.
NOTE: The dial turns
CLOCKWISE ONLY
. Forcing the clock face in the other
direction will destroy the timing gear. The timer will stop functioning when
unplugged or during a power failure, The correct time must be reset when power
is restored.
H. SAFETY OVERHEAT SHUT OFF
A thermal overload protector is built in to prevent overheating. When a potential
overheat temperature is reached, the heater will be automatically shut off. It can
only resume operation when the user resets the unit.
Loosen the upper brackets fixing screw,
pull sliding bracket in the lowest position,
and then tighten
the upper brackets fixing screw.
Brackets fixing screw
1
2
3
4
5
